Over the years Samsung has released a number of drivers for their mobile phones. The Samsung USB drivers at times have been generic while others had been made for a specific mobile phone in their range. Below you will find the most common USB driver for Samsung listed with their drivers on this website.
These are the older drivers for the Galaxy Prime mobile phone. You should try of the other generic software from Samsung if this does not work. Note that this software was designed for Windows XP, 7 And Windows 8 (32-Bit or 64-Bit) versions.
If you have a Samsung SFD-321U or an Iomega drive then trying to run this on a Windows 8 or Windows 10 system does not work too well. You can try the driver solution which is listed here or you can try a generic driver already on your computer. Follow the pictures below as the Iomega and Samsung uses the same driver as the NEC driver, however the NEC driver will run on Windows 8 and Windows 10.
If you have upgraded your operating system then errors can occur with the RTL8187 from Realtek. This should solve your issues with getting your system back online. Its takes a bit of PC knowledge. Follow the directions below and see also the driver for Windows 10 below. The other RTL8187 drivers can be found on this website.
There are a number of webcam drivers on the internet however finding their drivers can be difficult as most drivers are removed after about 2-3 years as new hardware is pushed to purchase. There are a number of webcam drivers on this website and below are some of the most common.
Bluetooth is not as popular as USB so there are limited software and hardware options. The following are Bluetooth drivers which may work on your computer. Check your hardware first before you install any of the drivers.
The USB error called “please insert device” normally occurs with portable hard drives. There can be a number of issues however the most common is that the drive has been damaged and will either need to be formatted or thrown away. Very rarely is it anything else.
USB ports can present problems for a number of reasons. These have been covered on this website under a number of headings. Always ensure that you have the correct USB driver for the device before we start on the USB issue.
Certain devices do not always work on the front ports of your computer. Many will only work on the rear USB ports. If you are not able to connect to the device on the front USB ports then try the rear. This tends to occur on Gigabyte motherboards and the Dell series of computers such as the Vostro 220s.
If you have a USB device and want to eject the USB device faster then you should consider installing USB Ejector. Normally you need to wait about 30 seconds for it to be safe to remove the USB attached device. With this piece of software you no longer have to wait for this to occur.