The username and passport word the Aztech HW550-3G Router as well as the user manual has been added below. The router may use of the IP’s listed below for when you login. You can download the user manual of the Aztech HW550-3G Router and see from there how to reset the router back to its factory settings. Note that when you reset this might not be to the settings of your ISP so you have to be careful about this. This could make your router unusable. You have been warned.
Aztech HW550-3G Router
There are a number of routers for the Aztech stable. These also include the Aztech DSL5018EN router as well as the Aztech DSL1000EW-L router which are also on this website. Most times the IP on the Aztech HW550-3G is 10.100.1.1 which would be the default login IP for the router. You can also read the Aztech HW550-3G manual for easier understanding. These are the main IP’s for routers –
If the original IP does not work. Then try the other IP’s as seen above.
|Aztech HW550-3G User Manual
If you wish to change the DNS server. Many want to use a faster DNS server and you can do this on your router. Most use this in order to block websites on their corporate network. You can see what the DNS is for Google which is free. The process for changing the router DNS is shown below. You will see the default username and password for the router. See also the Aztech Router Username Password as well as the Aztech DSL600E as well as the Aztech HW550-3G and Aztech DSL7000GRV-S routers.
Change the DNS on the Aztech HW550-3G router
|Login > Click on Advanced Mode > Click on Network > Click on Local > Add the IP’s in Primary DNS Server and Secondary DNS Server > Click Apply and Reboot
|Use Google Public DNS, use the following settings:
See how to change the IP on the router. See how to do this but dont forget the IP which you have chosen as you might not remember what the IP was a few months down the line. Normally people write the new IP on the cover of the router. See below how this is done.
Change the IP Address on the Aztech HW550-3G router
|Login > Click on Advanced Mode > Click on Network > Click on Router IP Address > Add your IP address
|Ensure that the Subnet Mask at 255.255.255.0 remains the same and leave the DHCP enabled.
The default username and password is as you can above. Note that there are many other drivers on this website. These include the cp2102 driver, csr bluetooth driver windows 7 as well as the prolific usb to serial driver amongst others.